Reference Guide

snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Z-Series
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
If the interface is expected to flap during normal usage, you could disable this command.
Syslog Commands
The following commands allow you to configure logging functions on all Dell Networking switches.
clear logging
Clear the messages in the logging buffer.
Z-Series
Syntax
clear logging
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
1327