Reference Guide

Usage
Information
The range is 0 to 11. Enabling this command keeps the failed switch in the Failed state. The
switch does not reboot until it is manually rebooted. When enabled, it is not displayed in the
running-config. When disabled, it is displayed in the running-config.
Related
Commands
show redundancy — displays the current redundancy status.
redundancy force-failover stack-unit
Force the standby unit in the stack to become the management unit.
Z9000
Syntax
redundancy force-failover stack-unit
Parameters
stack-unit Enter the stack unit. For the Z9000, the range is from 0 to 7.
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the members option.
Version 7.7.1.0 Introduced on the S-Series.
redundancy protocol
Enable hitless failover for a protocol.
Z9000
Syntax
redundancy protocol
Protocols
lacp Enter the LACP protocol
xstp Enter one of the following protocols: STP, RSTP, MSTP, PVST.
1352