Reference Guide

debug dot1x
Display 802.1X debugging information.
Z9000
Syntax
debug dot1x [all | auth-pae-fsm | backend-fsm | eapol-pdu]
[interface interface]
Parameters
all Enable all 802.1X debug messages.
auth-pae-fsm Enable authentication PAE FSM debug messages.
backend-fsm Enable backend FSM debug messages.
eapol-pdu Enable the EAPOL frame trace and related debug messages.
interface
interface
Restricts the debugging information to an interface.
Defaults Disabled
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.4.1.0 Introduced on the C-Series and S-Series.
dot1x auth-fail-vlan
Configure an authentication failure VLAN for users and devices that fail 802.1X authentication.
Z9000
Syntax
dot1x auth-fail-vlan vlan-id [max-attempts number]
To delete the authentication failure VLAN, use the no dot1x auth-fail-vlan vlan-
id [max-attempts number] command.
Parameters
vlan-id Enter the VLAN Identifier. The range is from 1 to 4094.
max-attempts
number
(OPTIONAL) Enter the keywords max-attempts followed number
of attempts desired before authentication fails. The range is from 1 to
5. The default is
3.
136