Reference Guide

Related
Commands
disable — disables spanning tree group 0. To enable spanning tree group 0, use the no
disable command.
show config
Display the current configuration for the mode. Only non-default values display.
Z-Series
Syntax
show config
Command Modes SPANNING TREE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(config-stp)#show config
protocol spanning-tree 0
no disable
FTOS(config-stp)#
show spanning-tree 0
Display the spanning tree group configuration and status of interfaces in the spanning tree group.
Z9000
Syntax
show spanning-tree 0 [active | brief | guard | interface
interface | root | summary]
Parameters
0 Enter 0 (zero) to display information about that specific spanning tree
group.
1378