Reference Guide

Version 8.3.12.0 Introduced on the S4810.
Example
VLT ARP Statistics
----------------
ARP Tunnel Pkts sent:0
ARP Tunnel Pkts Rcvd:0
ARP-sync Pkts Sent:0
ARP-sync Pkts Rcvd:0
ARP Reg Request sent:19
ARP Reg Request rcvd:10
Related
Commands
show vlt statistics — displays statistics on VLT operations.
delay-restore
Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer switches.
Z-Series
Syntax
delay-restore
Parameters
delay-restore Enter the amount of time, in seconds, to delay bringing up the VLT
ports after the VLTi device is reloaded or after the peer-link is
restored between VLT peer switches. The range from 1 to 1200. The
default is 90 seconds.
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S8420T.
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
To delay the system from bringing up the VLT port for a brief period to allow IGMP Snooping
and Layer 3 routing protocols to converge, use the delay-restore parameter. Use this
feature:
• after a VLT device is reloaded.
• if the Peer VLT device was up at the time the VLTi link failed to the time when it was
restored.
1427