Reference Guide

The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the
same, a syslog message is generated and VLT does not launch.
Related
Commands
show vlt — uses the show vlt brief command to display the delay-restore value.
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached
device.
Z-Series
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number Enter the respective vlt port-channel number of the peer device.
Defaults Not configured.
Command Modes INTERFACE PORT-CHANNEL
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
1442