Reference Guide

55
Virtual Router Redundancy Protocol (VRRP)
Virtual router redundancy protocol (VRRP) is supported by the Dell Networking operating system (FTOS) on the Z-Series
platform.
IPv4 VRRP Commands
The following are IPv4 VRRP commands.
advertise-interval
Set the time interval between VRRP advertisements.
Z-Series
Syntax
advertise-interval seconds
To return to the default settings, use the no advertise-interval command.
Parameters
seconds Enter a number of seconds. The range is from 1 to 255. The default is 1
second.
Defaults 1 second
Command Modes INTERFACE-VRRP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
Dell Networking recommends keeping the default setting for this command. If you do change
the time interval between VRRP advertisements on one router, change it on all routers.
1443