Reference Guide

show config
View the non-default VRRP configuration.
Z-Series
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group
configuration information, including defaults.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active VRRP group.
Z9000
Syntax
show vrrp [vrrp-id] [interface] [brief][ipv6]
Parameters
vrrp-id (OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to
view only that group. The range is from 1 to 255.
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For Port Channel interface types, enter the keywords port-
channel then the number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
1450