Reference Guide

• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface.
Save the configuration and reload the system for the delay timers to take effect.
Related
Command
vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Z-Series
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is
configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.
Related
Command
virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
1456