Reference Guide

Extended IP ACL Commands
When an ACL is created without any rule and then applied to an interface, ACL behavior reflects an implicit permit.
The following commands configure extended IP ACLs, which in addition to the IP address, also examine the packet’s
protocol type.
The Z9000 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
deny
Configure a filter that drops IP packets meeting the filter criteria.
Z9000
Syntax
deny {ip | ip-protocol-number} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [count
[byte] | log] [dscp value] [order] [monitor] [fragments]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• Use the no deny {ip | ip-protocol-number} {source mask | any
| host ip-address} {destination mask | any | host ip-
address
} command.
Parameters
ip Enter the keyword ip to configure a generic IP access list. The
keyword
ip specifies that the access list denies all IP protocols.
ip-protocol-
number
Enter a number from 0 to 255 to deny based on the protocol identified
in the IP protocol header.
source Enter the IP address of the network or host from which the packets
were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
noncontiguous.
any Enter the keyword any to specify that all routes are subject to the
filter.
host ip-address Enter the keyword host then the IP address to specify a host IP
address.
destination Enter the IP address of the network or host to which the packets are
sent.
count (OPTIONAL) Enter the keyword count to count packets that the filter
processes.
byte (OPTIONAL) Enter the keyword byte to count bytes that the filter
processes.
168