Reference Guide

Parameters
access-list-name Enter the name of a configured MAC access list, up to 140 characters.
vlan vlan-range (OPTIONAL) Enter the keyword vlan and then enter a range of
VLANs. The range is from 1 to 4094 (you can use IDs 1 to 4094).
NOTE: This option is available only with the keywordin option.
in Enter the keyword in to configure the ACL to filter incoming traffic.
out Enter the keyword out to configure the ACL to filter outgoing traffic.
NOTE: The option is not available on the S-Series.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
You can assign one ACL (standard or extended) to an interface.
Related
Commands
mac access-list standard — configures a standard MAC ACL.
mac access-list extended — configures an extended MAC ACL.
show mac access-lists
Display all of the Layer 2 ACLs configured in the system, whether or not they are applied to an interface, and the count of
matches/mismatches against each ACL entry displayed.
Z9000
Syntax
show mac access-lists [access-list-name] [interface interface]
[in | out]
193