Reference Guide

set automatic-tag
To automatically compute the tag value of the route, configure a filter.
Z9000
Syntax
set automatic-tag
To return to the default, enter no set automatic-tag.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set level — specify the OSPF area for route redistribution.
set metric — specify the metric value assigned to redistributed routes.
set metric-type — specify the metric type assigned to redistributed routes.
set tag — specify the tag assigned to redistributed routes.
set comm-list delete
To remove the specified community list from the BGP route’s COMMUNITY attribute, configure a filter.
Z9000
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set comm-list
community-list-name delete command.
Parameters
community-list-
name
Enter the name of an established Community list, up to 140
characters.
Defaults Not configured.
228