Reference Guide

Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
bfd enable (Interface)
Enable BFD on an interface.
Z9000
Syntax
bfd enable
Defaults BFD is enabled on all interfaces when you enable BFD from CONFIGURATION mode.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.10.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
bfd interval
Specify non-default BFD session parameters beginning with the transmission interval.
Z9000
Syntax
bfd interval interval min_rx min_rx multiplier value role
{active | passive}
Parameters
interval
milliseconds
Enter the keywords interval to specify non-default BFD session
parameters beginning with the transmission interval. The range is
from 50 to 1000. The default is
100.
246