Reference Guide

neighbor local-as
To accept external routes from neighbors with a local AS number in the AS number path, configure Internal BGP (IBGP)
routers.
Z-Series
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-
prepend]
To return to the default value, use the no neighbor {ip-address | peer-group-
name} local-as command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to set the advertisement interval for
all routers in the peer group.
as-number Enter the AS number to reset all neighbors belonging to that AS. The
range is from 0 to 65535 (2 byte), from 1 to 4294967295 (4 byte) or from
0.1 to 65535.65535 (dotted format).
no prepend Specifies that local AS values do not prepend to announcements from
the neighbor.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
neighbor maximum-prefix
Control the number of network prefixes received.
Z-Series
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum
[threshold] [warning-only]
To return to the default values, use the no neighbor {ip-address | peer-group-
name
} maximum-prefix maximum command.
301