Reference Guide

neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
Z-Series
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-name}
remove-private-as command.
Parameters
ip-address Enter the IP address of the neighbor to remove the private AS
numbers.
peer-group-name Enter the name of the peer group to remove the private AS numbers.
Defaults Disabled (that is, private AS number are not removed).
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Usage
Information
Applies to EBGP neighbors only.
Configure your system to accept 4-byte formats before entering a 4 byte AS Number.
If the AS-PATH contains both public and private AS number or contains AS numbers of an
EBGP neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the
private AS numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are from 64512 to 65535 (2 byte).
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Z-Series
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in
| out}
To remove the route map, use the no neighbor {ip-address | peer-group-
name
} route-map map-name {in | out} command.
308