Reference Guide

show ip bgp community-list
View routes that a specific community list affects.
Z-Series
Syntax
show ip bgp [ipv4 unicast] community-list community-list-name
[exact-match]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
community-list-
name
Enter the name of a configured IP community list (maximum 140
characters).
exact-match Enter the keyword for an exact match of the communities.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The show ip bgp community-list command without any parameters lists BGP routes
matching the Community List and the output is the same as for the show ip bgp command
output.
The following describes the show ip bgp community-list pass command shown in
the following example.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is listed in
this column, then local routes exist in the routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
328