Reference Guide

Version 9.2(0.2) Changed the default value from global 4q to Dynamic.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.0 Introduced on the Z9000.
Version 7.8.1.0 Added the global keyword.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Usage
Information
The buffer-profile global command fails if you have already applied a custom
buffer-profile on an interface. Similarly, when you configure buffer-profile global,
you cannot not apply buffer-profile on any interface.
If the default buffer-profile is active, FTOS displays an error message instructing you to remove
the default configuration using the no buffer-profile global command.
Reload the system for the global buffer-profile to take effect.
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
Z9000
Syntax
clear hardware stack-unit number {counters | unit number
counters | cpu data-plane statistics | cpu party-bus statistics
| stack-port number}
Parameters
stack-unit
number
Enter the keywords stack-unit then a number to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data.
The range is 0
to 7 for the Z9000.
counters Enter the keyword counters to clear the counters on the selected
stack member.
unit number
counters
Enter the keyword unit along with a port-pipe number, then the
keyword counters to clear the counters on the selected port-pipe.
The range is 0 to 1 for the Z9000.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics to clear the
data plane statistics.
391