Reference Guide

Defaults 60 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
Z9000
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time command.
Parameters
seconds Enter the number of seconds for the maximum response time. The
range is from 1 to 25. The default is 10 seconds.
Defaults 10 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
477