Reference Guide

off off off off
off off off off
off off off off
off off off off
off off off off
off on on off
off off off off
off off off off
on off off on
on on on on
on on on on
off off off off
off off off off
on on on on
on on on on
Related
Commands
show running-config — displays the flow configuration parameters (non-default values only).
show interfaces — displays the negotiated flow control parameters.
interface
Configure a physical interface on the switch.
Z9000
Syntax
interface interface range
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a null interface, enter the keyword null then the slot/
port information. The Null interface number is 0.
• For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then the slot/port information. The range is from 0 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the
tunnel ID. The range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then the slot/
port information. The range is from 1 to 4094.
range (Optional) Enter the keyword range to configure an interface range.
Defaults Not configured.
Command Modes CONFIGURATION
500