Reference Guide

Usage
Information
You cannot delete the Null interface. The only configuration command possible in a Null
interface is ip unreachables.
Example
FTOS(conf)#interface null 0
FTOS(conf-if-nu-0)#
Related
Commands
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
ip unreachables — enables generation of internet control message protocol (ICMP)
unreachable messages.
interface range
This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk
configuration). Using the interface range command, you can enter identical commands for a range of interface.
Z9000
Syntax
interface range interface, interface,...
Parameters
interface,
interface,...
Enter the keywords interface range and one of the interfaces
— slot/port, port-channel, or VLAN number. Select the range of
interfaces for bulk configuration. You can enter up to six comma-
separated ranges. Spaces are not required between the commas.
Comma-separated ranges can include VLANs, port-channels, and
physical interfaces.
Slot/Port information must contain a space before and after the dash.
For example, interface range gigabitethernet 0/1 -
5 is valid; interface range gigabitethernet 0/1-5 is
NOT valid.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a Tunnel interface, enter the keyword Tunnel then a
number from 1 to 16383.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
504