Reference Guide

Related
Commands
show interfaces switchport — displays the configuration of switchport (Layer 2) interfaces on
the switch.
switchport — places the interface in a Layer 2 mode.
vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN network.
rate-interval
Configure the traffic sampling interval on the selected interface.
Z9000
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data. The
range is from 5 to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the number of
seconds designated here rounds to the multiple of 15 seconds
lower than the entered value. For example, if 44 seconds is
designated, it rounds to 30; 45 to 59 seconds rounds to 45.
Defaults 299 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced
Usage
Information
The output of the show interfaces command displays the configured rate interval, along
with the collected traffic data.
Related
Commands
show interfaces — displays information on physical and virtual interfaces.
516