Reference Guide

Version 9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
management egress-interface-selection
To make configured application traffic egress through the management port instead of the front-end (FE) port, enable
and configure a management egress interface.
Z9000
Syntax
management egress-interface-selection
To disable and remove management egress interface selection (EIS) configurations, use the
no management egress-interface-selection command.
Defaults None.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
show ip management-eis-route
Display the management routes used by EIS.
Z9000
Syntax
show ip management-eis-route
Defaults None.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
Example
FTOS#show ip management-eis-route
Destination Gateway State Route Source
----------- ------- ----- ------------
10.11.0.0/16 ManagementEthernet 0/0 Connected Connected
172.16.1.0/24 10.11.192.4 Active Static
546