Reference Guide

Related
Commands
description — assigns a descriptive text string to the interface.
interface port-channel — creates a Port Channel interface.
shutdown — disables/enables the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
Z9000
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identifies this LAG fate-
sharing group.
port-channel
number
Enter the keywords port-channel then an existing LAG number.
Enter this keyword/variable combination twice, identifying the two
paired LAGs.
Defaults none
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related
Commands
port-channel failover-group — accesses PORT-CHANNEL FAILOVER-GROUP mode to
configure a LAG failover group.
show interfaces port-channel — displays information on configured Port Channel groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing eight physical interfaces on the S-
Series.
Z9000
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number
command.
550