Reference Guide

ah-authentication Enter the keywords ah-authentication then the transform type
of operation to apply to traffic. The transform type represents the
encryption or authentication applied to traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
• null — Causes an encryption policy configured for the area to
not be inherited on the interface.
esp-
authentication
Enter the keywords esp-authentication then the transform
type of operation to apply to traffic. The transform type represents the
encryption or authentication applied to traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
• null — Causes an encryption policy configured for the area to
not be inherited on the interface.
esp-encryption Enter the keywords esp-encryption then the transform type of
operation to apply to traffic. The transform type represents the
encryption or authentication applied to traffic.
• 3des — Use 3DES encryption.
• cbc — Use CDC encryption.
• des — Use DES encryption.
• null — Causes an encryption policy configured for the area to
not be inherited on the interface.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
• Both sides of the link must specify the same transform set.
• You can create up to 64 transform sets.
Example
FTOS(conf)#int ten 0/4
FTOS(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
FTOS(conf)#int ten 0/6
FTOS(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
566