Reference Guide

Parameters
unit-number Enter the number of the stack unit. The range is from 0 to 7.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.19.0 Introduced on the S4820T.
Usage
Information
To clear Layer 3 CAM inconsistencies, use this command.
CAUTION: Executing this command causes traffic disruption.
Related
Commands
show ip fib stack-unit — shows FIB entries on a specified stack-unit.
clear ip route
Clear one or all routes in the routing table.
Z9000
Syntax
clear ip route {* | ip-address mask}
Parameters
* Enter an asterisk (*) to clear all learned IP routes.
ip-address mask Enter a specific IP address and mask in dotted decimal format to
clear that IP address from the routing table.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.6.1.0 Introduced on the S-Series.
579