Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.3.1.0 Introduced for the E-Series.
Usage
Information
This command disables the incrementing of the hops field when boot requests are relayed to a
DHCP server through FTOS. If the incoming boot request already has a non-zero hops field, the
message is relayed with the same value for hops. However, the message is discarded if the
hops field exceeds 16, to comply with the relay agent behavior specified in RFC 1542.
Related
Commands
ip helper-address — specifies the destination broadcast or host address for DHCP server
requests.
show running-config — displays the current configuration and changes from the default
values.
ip host
Assign a name and IP address the host-to-IP address mapping table uses.
Z9000
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name Enter a text string to associate with one IP address.
ip address Enter an IP address, in dotted decimal format, to be mapped to the
name.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
593