Reference Guide

Version 9.0.0.0 Introduced on the Z9000 and added support for IPv6.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static
route (or a protocol route) is preferred over the Management Static route. Also, Management
static routes and the Management Connected prefix are not reflected in the hardware routing
tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This
command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the
Primary or Standby RPM).
duplex (Management) — sets the mode of the Management interface.
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table.
Z9000
Syntax
show arp [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [retries] [static |
dynamic] [inspection {database | statistics][summary]
Parameters
interface
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For the Management interface, enter the keyword
managementethernet then the slot/port information.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
605