Reference Guide

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a stack-unit interface, enter the keyword stack-unit
then the stack unit number. The range is from 0 to 7.
• For a tunnel interface, enter the keyword tunnel then the
tunnel interface number. The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the
interfaces and whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical
interfaces with non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.2 Supported on the E-Series ExaScale E600i.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ip interface command shown in the following
example.
Lines Description
TenGigabitEthernet
0/0...
Displays the interface’s type, slot/port, and physical and line protocol
status.
Internet address... States whether an IP address is assigned to the interface. If an IP
address is assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
621