Reference Guide

cam-acl-egress
Allocate space for IPv6 egress ACLs.
Z9000
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl
1- 4 ipv6acl 0-4
Allocate space to support IPv6 ACLs. Enter all of the profiles and a
range. Enter the CAM profile name then the amount to be allotted.
The total space allocated must equal 13. The ipv6acl range must
be a factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-
mem
or copy run start), then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these blocks cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is
from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
Example
FTOS#
FTOS#configure
FTOS(conf)#cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
FTOS(conf)#cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
FTOS(conf)#cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
643