Reference Guide

clear ipv6 route
Clear (refresh) all or a specific route from the IPv6 routing table.
Z9000
Syntax
clear ipv6 route {* | ipv6-address prefix-length}
Parameters
* Enter the * to clear (refresh) all routes from the IPv6 routing table.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix length in
the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
clear ipv6 mld_host
Clear the IPv6 MLD host counters and reset the elapsed time.
Z9000
Syntax
clear ipv6 mld_host
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
648