Reference Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Because this command is enabled by default, it does not appear in the running configuration.
When you disable unicast routing, the no ipv6 unicast-routing command is included
in the running configuration. Whenever unicast routing is disabled or re-enabled, FTOS
generates a syslog message indicating the action.
Disabling unicast routing on an E-Series chassis causes the following behavior:
• static and protocol learned routes are removed from RTM and from the CAM; packet
forwarding to these routes is terminated
• connected routes and resolved neighbors remain in the CAM and new IPv6 neighbors
are still discoverable
• additional protocol adjacencies (OSPFv3 and BGP4) are brought down and no new
adjacencies are formed
• the IPv6 address family configuration (under router bgp) is deleted
• IPv6 Multicast traffic continues to flow unhindered
show ipv6 cam stack-unit
Displays the IPv6 CAM entries for the specified stack-unit.
Z9000
Syntax
show ipv6 cam stack-unit unit-number port-set {0-1} [summary |
index | ipv6 address]
Parameters
unit-number Enter the stack unit’s ID number. The range is from 0 to 11.
port-set Enter the keyword Port Set.
summary (OPTIONAL) Enter the keyword summary to display a table listing
network prefixes and the total number prefixes which can be entered
into the IPv6 CAM.
659