Reference Guide

show ipv6 flowlabel-zero
Display the flow label zero setting.
Z9000
Syntax
show ipv6 flowlabel-zero
Default Disabled
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Related
Commands
ipv6 nd dad attempts — Configure system to set the flow label field in the packets to zero.
show ipv6 interface
Display the status of interfaces configured for IPv6.
Z9000
Syntax
show ipv6 interface interface [brief] [configured]
[gigabitethernet slot | slot/port] [loopback interface-number]
[managementethernet slot/port] [port-channel number] [stack-
unit id] [tengigabitethernet slot | slot/port] [fortyGigE slot
| slot/port] [tunnel tunnel-id] [vlan vlan-id]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword Loopback
then a number from 0 to 16383.
• For the Null interface, enter the keyword null then zero (0).
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For stacking, enter the keywords stack-unit then the
stack-unit ID.
662