Reference Guide

Usage
Information
If you enter bgp dampening, the default values for half-life, reuse, suppress, and
max-suppress-time are applied. The parameters are position-dependent; therefore, if
you configure one parameter, you must configure the parameters in the order they appear in
the command.
Related
Commands
show ip bgp ipv6 unicast dampened-paths – views the BGP paths.
bgp default local-preference
Change the default local preference value for routes exchanged between internal BGP peers.
Z9000
Syntax
bgp default local-preference value
To return to the default value, use the no bgp default local-preference
command.
Parameters
value Enter a number to assign to routes as the degree of preference for
those routes. When routes are compared, the higher the degree of
preference or local preference value, the more the route is preferred.
The range is from 0 to 4294967295. The default is 100.
Defaults 100
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant Dell FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
680