Reference Guide

FTOS(conf-if-te-0/5)#ipv6 nd prefix FEC0::/10
FTOS(conf-if-te-0/5)#
FTOS(conf-if-te-0/5)#show conf
!
interface TenGigabitEthernet 0/5
ip address 78.21.1.3/24
ipv6 nd prefix fec0::/10
flowcontrol rx on tx on
no shutdown
FTOS(conf-if-te-0/5)#
FTOS#
upgrade
Upgrade the bootflash image or system image of the management unit.
Z9000
Syntax
upgrade {boot | system} {ftp: | scp: | tftp: | flash: {A: |B:}
| stack-unit | usbflash | slot0:} file-url
Parameters
boot Enter the keyword boot to change the boot image.
system Enter the keyword system to change the system image.
ftp: After entering the keyword ftp:, you can either follow it with the
location of the source file in this form:
//
userid:password@hostip/filepath or press Enter to
launch a prompt sequence.
scp: After entering the keyword scp:, you can either follow it with the
location of the source file in this form:
//
userid:password@hostip/filepath or press Enter to
launch a prompt sequence.
slot0: After entering the keyword slot0:, you can either follow it with the
location of the source file in this form: //hostlocation/
filepath or press Enter to launch a prompt sequence.
tftp: After entering the keyword tftp:, you can either follow it with the
location of the source file in this form: //hostlocation/
filepath
or press Enter to launch a prompt sequence.
flash: After entering the keyword flash:, you can either follow it with the
location of the source file in this form: flash//filepath or press
Enter to launch a prompt sequence.
A: | B: Enter the partition to upgrade from the flash.
stack-unit: Enter the keywords stack-unit: to synch the image to the stack-
unit.
file-url Enter the following location keywords and information to upgrade
using an FTOS image other than the one currently running:
70