Reference Guide

Usage
Information
If you enable this command, use the capture bgp-pdu max-buffer-size command
to recompute the best path.
neighbor activate
This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI.
Z9000
Syntax
neighbor {ipv6-address | peer-group-name} activate
To disable, use the no neighbor {ipv6-address | peer-group-name}
activate command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name Identify a peer group by name.
activate Enter the keyword activate to enable the identified neighbor or
peer group in the new AFI/SAFI.
Defaults Disabled.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant Dell FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
By default, when you create a neighbor/peer group configuration in the Router BGP context, it
is enabled for the IPv6/Unicast AFI/SAFI. By using activate in the new context, the
neighbor/peer group is enabled for AFI/SAFI.
706