Reference Guide

Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant Dell FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
neighbor shutdown
Disable a BGP neighbor or peer group.
Z9000
Syntax
neighbor {ipv6-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the no neighbor {ipv6-address |
peer-group-name} shutdown command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name Enter the name of the peer group to disable or enable all routers
within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant Dell FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
723