Reference Guide

To remove a weight value, use the no neighbor {ipv6-address | peer-group-
name} weight weight command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name Enter the name of the peer group to set the timers for all routers
within the peer group.
weight Enter a number as the weight. The range is from 0 to 65535. The
default is 0.
Defaults 0
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant Dell FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
In the system best path selection process, the path with the highest weight value is preferred.
NOTE: To apply the weight to the connection and recompute the best path, reset the
neighbor connection (the capture bgp-pdu max-buffer-size * command).
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Z9000
Syntax
network ipv6-address prefix-length [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-
name] command.
Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix length in
the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
728