Reference Guide

map-name Enter the name of an established route map. If the Route map is not
configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
Z9000
Syntax
neighbor {ipv6-address | peer-group-name} route-reflector-
client
To indicate that the neighbor is not a route reflector client or to delete a route reflector
configuration, use the no neighbor {ipv6-address | peer-group-name}
route-reflector-client
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name Enter the name of the peer group. All routers in the peer group
receive routes from a route reflector.
Defaults Not configured.
768