Manualshelf

Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 Z9000
821822823824825826827828829830
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.12.0 Introduced on the S4810.
Version 7.8.1.0 Introduced.
net
To configure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If you did not
configure a NET, the IS-IS process does not start.
Z9000
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-
title
Specify the area address and system ID for an IS-IS routing process.
The first 1 to 13 bytes identify the area address. The next 6 bytes
identify the system ID. The last 1 byte is the selector byte, always
identified as zero zero (00). This argument can be applied to an
address or a name.
Defaults Not configured.
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant
FTOS Command Line Reference Guide
.
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that interface.
Z9000
Syntax
passive-interface interface
824