Reference Guide

To delete a passive interface configuration, use the no passive-interface
interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For Loopback interface, enter the keyword loopback then
a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a SONET interface, enter the keyword sonet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
Defaults Not configured.
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
Although the passive interface does not send nor receive routing updates, the network on that
interface is still included in the IS-IS updates sent using other interfaces.
redistribute
Redistribute routes from one routing domain to another routing domain.
Z9000
Syntax
redistribute {static | connected | rip} [level-1 | level-1-2 |
level-2] [metric metric-value] [metric-type {external |
internal}] [route-map map-name]
To end redistribution or disable any of the specified keywords, use the no redistribute
{static | connected | rip} [metric metric-value] [metric-type
{external | internal}] [level-1 | level-1-2 | level-2] [route-
map map-name] command.
825