Reference Guide

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
port-channel mode
Configure the LACP port channel mode.
Z-Series
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords number then a number.
active Enter the keyword active to set the mode to the active state.
NOTE: LACP modes are defined in Usage Information .
passive Enter the keyword passive to set the mode to the passive state.
NOTE: LACP modes are defined in Usage Information .
off Enter the keyword off to set the mode to the off state.
NOTE: LACP modes are defined in Usage Information .
Defaults off
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
LACP Modes
Mode
Function
active An interface is in an active negotiating state in this mode. LACP runs
on any link configured in the active state and also automatically
initiates negotiation with other ports by initiating LACP packets.
849