Reference Guide

Usage
Information
The no default vlan disable command is not listed in the running-configuration, but
when the default VLAN is disabled, default-vlan disable is listed in the running-
configuration.
name
Assign a name to the VLAN.
Z9000
Syntax
name vlan-name
To remove the name from the VLAN, use the no name command.
Parameters
vlan-name Enter up to 32 characters as the name of the VLAN.
Defaults Not configured.
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To display information about a named VLAN, enter the show vlan command with the name
parameter or the show interfaces description command.
Related
Commands
description — assigns a descriptive text string to the interface.
interface vlan — configures a VLAN.
show vlan — displays the current VLAN configurations on the switch.
show config
Display the current configuration of the selected VLAN.
Z9000
Syntax
show config
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
872