Reference Guide

fefd disable
Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.
Z9000
Syntax
fefd disable
To re-enable FEFD on an interface, use the no fefd disable command.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Legacy E-Series
command.
Usage
Information
When you enter no fefd for an interface and fefd-global, FEFD is enabled on the interface
because the no fefd command is not retained in the configuration file. To keep the interface
FEFD disabled when the global configuration changes, use the
fefd reset command.
Related
Commands
• fefd reset — enables FEFD globally on the system.
• fefd mode — changes FEFD mode on an interface.
fefd interval
Set an interval between control packets.
Z9000
Syntax
fefd interval seconds
To return to the default value, use the no fefd interval command.
Parameters
seconds Enter a number as the time between FEFD control packets. The range
is from 3 to 300 seconds. The default is 15 seconds.
Defaults 15 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
882