Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Before LLDP can be configured on an interface, it must be enabled globally from
CONFIGURATION mode. This command places you in LLDP mode on the interface; it does not
enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global configurations.
When you execute the no protocol lldp from INTERFACE mode, interfaces begin to
inherit the configuration from global LLDP CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Z9000
Syntax
show lldp neighbors [interface] [detail]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/ port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
detail (OPTIONAL) Enter the keyword detail to display all the TLV
information, remote management IP addresses, timers, and LLDP tx
and rx counters.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1.(0.0) Modified output of detail parameter to display remote management IP
addresses.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
899