Reference Guide

Version 7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med video-signaling
To advertise video control packets that use a separate network policy than video data, configure the system.
Z9000
Syntax
advertise med video-signaling {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med video-signaling {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority (C-Series and E-Series only). The range is
from 0 to 7.
DSCP_value Enter the DSCP value (C-Series and E-Series only). The range is from
0 to 63.
priority-tagged
number
Enter the keywords priority-tagged then the Layer 2 priority.
The range is from 0 to 7.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
908