Reference Guide

Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The distribute-list out command applies to routes autonomous system boundary
routers (ASBRs) redistributes into OSPF. It can be applied to external type 2 and external type 1
routes, but not to intra-area and inter-area routes.
enable inverse-mask
By default, FTOS allows you to input the OSPF network command with a net-mask. This command provides a choice
between inverse-mask or net-mask (the default).
Z9000
Syntax
enable inverse mask
To return to the default net-mask, use the no enable inverse mask command.
Defaults net-mask
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route computation so
that convergence takes less time.
Z9000
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
Parameters
number Enter the convergence level desired. The higher this parameter is set,
the faster OSPF converge takes place. The range is from 1 to 4.
Defaults none.
966