Reference Guide

ip ospf network
Set the network type for the interface.
Z9000
Syntax
ip ospf network {broadcast | point-to-point}
To return to the default, use the no ip ospf network command.
Parameters
broadcast Enter the keyword broadcast to designate the interface as part of
a broadcast network.
point-to-point Enter the keywords point-to-point to designate the interface
as part of a point-to-point network.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
ip ospf priority
To determine the designated router for the OSPF network, set the priority of the interface.
Z9000
Syntax
ip ospf priority number
To return to the default setting, use the no ip ospf priority command.
Parameters
number Enter a number as the priority. The range is from 0 to 255. The default
is 1.
Defaults 1
Command Modes INTERFACE
976