Administrator Guide

Version 8.3.7.1 Introduced on the S4810.
Version 8.2.1.0 Introduced the hardware shutdown-on-violation option.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced on the E-Series.
Usage
Information
On an MSTP switch, a port configured as an edge port immediately transitions to
the Forwarding state. Only configure ports connected to end-hosts as edge ports.
Consider an edge port similar to a port with spanning-tree portfast enabled.
If you do not enable shutdown-on-violation, BPDUs are still sent to the RPM
CPU.
tc-flush-standard
Enable the MAC address flushing after receiving every topology change notification.
Z9000
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced
Multiple Spanning Tree Protocol (MSTP)
1015