Administrator Guide

Version 8.3.1.0 Introduced
Usage
Information
Do not enter this command before creating the access-list.
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds
command.
Parameters
seconds Enter a number as the number of seconds between router
query messages. The range is from 0 to 65535. The default is
30 seconds.
Defaults 30 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.4.1.0 Introduced
ipv6 pim register-filter
Configure the source DR so that it does not send register packets to the RP for the specified sources and
groups.
Syntax
ipv6 pim register-filter access-list
Parameters
access-list Enter the name of the extended ACL that contains the
sources and groups to filter.
Defaults none
PIM-Sparse Mode (PIM-SM)
1181