Administrator Guide

bandwidth configured is adjusted according to the bandwidth available after
reserving for multicast bandwidth.
queue ingress
Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the Multicast
bandwidth queue.
Syntax
queue ingress multicast {linecard slot number port-set number |
all} [wred-profile name]
To return to the default, use the no queue ingress multicast {linecard
slot number port-set number | all} [wred-profile name] command.
Parameters
linecard
number
Enter the keyword linecard then the line card slot number.
port-set
number
Enter the keywords port-set then the line card’s port pipe.
The range is from 0 or 1.
all Enter the keyword all to apply to all line cards.
wred-profile
name
(OPTIONAL) Enter the keywords wred-profile then your
WRED profile name in character format (16 character
maximum). Or use one of the pre-defined WRED profile
names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Version 7.4.1.0
and 6.5.3.0
Introduced on the E-Series.
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of
queues. The WRED Curve is applied to all eight ingress Multicast queues.
1244
Quality of Service (QoS)